Hello friends, in this article we will share with you the solution to fix Samsung Galaxy A12 phone charging stopped due to temperature. You only need to replace the thermistor on the Samsung charging board when the Galaxy A12 A125F charging is paused.
Samsung Galaxy A12 Charging Paused Problem issue is known to be the most common problem and this is mostly due to physical damage or water damage to the charging connector pin also causing problems with the phone's charging connector. However, there can also be other reasons for this problem like a faulty charger or the battery of the phone.
If your Samsung Galaxy A12 started getting paused charging error, first you need to see if there is a problem with the charging port or the accessory. This error can sometimes be caused by a faulty USB cable or charger, you can use an original Samsung cable and charger or charge another Samsung device with current ones. Either way will help you figure out if there's a problem with your accessory.
Also, try to see if there is any dirt, lint, debris or foreign object in the charging port that could be clogging the charging cable. The presence of dirt or debris in the port is the usual reason why charging fails. If you think the port is dirty and causing the paused charging problem, clean the port using a can of compressed air. Avoid sticking anything in the port so as not to damage the system.
Samsung Galaxy A12 charging problem paused
- Battery temperature too low.
- Samsung Galaxy A12 heats up during charging.
- No response when charger is connected.
Solution to fix Samsung Galaxy A12 charging pause problem
- The problem is that the charging is paused we call the thermistor.
- You need to remove the thermistor or replace it from another board.
- Just follow the image shown below.
To fix water damage, all you have to do is
Clean the charging board and check.
If the problem is not fixed or the pins are damaged then you will need to replace the entire charging board.
 |
| Samsung Galaxy A12 Charging Paused Problem |
Now check the voltage of the 1st pin (from the right) of the charging connector with the help of a multimeter, if there is a problem then solder the charging pin again.
Now check the voltage at the capacitor, if it is zero then check if there is a short or not if then replace the capacitor. If not:
Check the connection between the charging pin and the Capacitor, if the connection is broken, re-solder or put the connecting wire.
Charging is provided to the Samsung Galaxy A12 board via the Capacitor.
More information on this issue and solutions for new tips and tricks will be found on this page, if there is a new update we will update it. Here are some related articles you can refer to on how to repair mobile phones.
Tags:
Samsung
