You can easily get the Samsung Galaxy Note 20 Ultra 5G Test Point by following the full instructions below along with the image. By using ISP Pinout you can easily bypass FRP or reset user data on your device through EasyJTAG Plus Box or any other tool.
 |
| Samsung Galaxy Note 20 Ultra 5G Test Point |
You are trying to flash or remove FRP lock on Samsung Galaxy Note 20 Ultra SM-N986B mobile phone, that means you need to use Samsung Galaxy Note 20 Ultra UFS ISP Pinout to flash stock firmware, Remove Locks and FRP.
Schematic image of Samsung Galaxy S20 Ultra UFS ISP
- You need to take the back cover out of the phone, remove the motherboard from the battery, fingerprint sensor and camera.
- Remove the screws from the motherboard. Take it out and put it in a safe place.
- On the motherboard locate the six eMMC pins: TxOp, TxOn, RxOp, RxOn.
- Take the UFI box and take out the adapter, you will see the same pins in the adapter I mentioned above.
- Solder 4 pins: TxOp, TxOn, RxOp, RxOn with jumper between motherboard and adapter. Leave VCC and VCCQ for USB to power them.
- Put the adapter inside the UFI box, connect the box to the computer.
- Connect the motherboard to the phone's battery, put the USB cable in the phone and connect it to the computer.
Samsung Galaxy S20 Ultra FRP Lock with EasyJTAG Plus:
- Remove the back of the device and connect the wire to the UFS ISP Pinout.
- Correctly connect UFS ISP Pinout to EasyJTAG Plus box
- Check "UFS" tab
- Then click "Identify UFS Chip".
- Connect your Samsung Galaxy S21 Ultra to your PC via a USB cable.
- Go to Preset Select Persistent
- Now click Erase LUN0 Data
- Accomplished.
Tags:
Samsung
